Texas Instruments 990 User Manual page 59

Construction and Activation
Thi s message indi cates that remote SCI has been assi gned the same
network ID as the secondary station, in this case 1100. NETGEN
conti nues to prompt as follows:
REK>TE LOGGING INCLUDED (YIN): Y
This prompt provides the option of logging at either the primary
or the secondary station. If remote logging to the primary
syst em log is desi red, enter Y. If N is entered, no TX5 system
error messages will be written to the primary station. In this
case, if OCP is not incl uded in the TX5, system error messages
will be lost. IfN is entered, NETGEN skips to the TX5 TASK ID
prompt. If Y is entered, the next prompt is as follows:
REK>TE LOG NETWORK ID (0100 - 9999): 1101
The res:fX>nse to this prompt (1101 in the example) is the the
network ID assigned to the remote log task. NETGEN then issues
the following procedural message to indicate that the ID entered
in response to the previous prompt has been successfully assigned
to the remote log task:
REK>TE LOGGER (TASK >28) ASSICNED NETIDRK ID 1101
The ne xt prompt is as follows:
TXT AS KID (0 - > FF): > 10
The response to this prompt (>10 in the example) is the task ID
of a TX5 tas k that requi res a networ kID. The same tas k must now
be assigned a network ID if the artifici al data statistic will
ever be run to thi s TX5 secondar y station (see section 5). The
next prompt is as follows:
TX TASK NETWORK ID (0100 - 9999): 1102
The response to this prompt must
be
the network ID assigned to
the TX5 task (ID >10) that was entered in response to the
previous prompt. NETGEN continues to prompt for TX5 task IDs
until all are entered and assigned network IDs. When no more
tasks require ID assignments, enter a RETURN in reponse to the
last TX TASK ID prompt displayed.
The descr i ption of the TX5 secondar y station is now complete;
NETGEN proceeds to prompt for the next station, as described in
the following paragraph.
2270526-9701
3-13