Installing/Removing Main Memory - Fujitsu D2608 Operating Manual

Brief description of mainboard

Installing/removing main memory

Technical data
Technology
Total size
Module size
A current list of the memory modules recommended for this mainboard is available
on the Internet at: "http://ts.fujitsu.com/mainboards".
At least one memory module must be installed. Memory modules with different
memory capacities can be combined.
You may only use unbuffered 1.8 V memory modules with or without ECC.
DDR2-memory modules must meet the PC2-6400U or PC2-5300U
specification. DDR2-memory modules to the PC2-6400E or PC2-5300E
specification are also supported.
To prevent problems, do not use ECC and NON-ECC memory modules jointly.
The mainboard has two memory channels (channel A and channel B) with
two slots each (slot 1 and 3 or slot 2 and 4).
If you use more than one memory module, make sure to distribute the
memory modules over both memory channels. By doing this you use the
performance advantages of the dual-channel mode.
System performance is maximised when the same memory size is
used in Channel A and Channel B.
To simplify equipping, the slots are colour coded.
Slot to be used
Channel A, Slot 1
Channel B, Slot 2
Channel A, Slot 3
Channel B, Slot 4
The installation/removal is described in the "Basic information on mainboard" manual.
4 - English
DDR2 667/800 SDRAM unbuffered DIMM modules 240-Pin; 1.8V; 64
Bit, ECC possible
256 Mbytes to 8 Gbyte DDR2
256, 512, 1024 or 2048 Mbyte for one socket
slot 4
slot 3
1
x
Channel B
Channel A
Number of memory modules inserted
2
x
x
A26361-D2608-Z211-1-8N19, edition 1
slot 2
slot 1
3 4
x x
x x
x x
x