Advertisement
1.0 WARRANTY INFORMATION
Patton Electronics warrants all Model 571/581 components to be
free from defects, and will—at our option—repair or replace the product
should it fail within one year from the first date of shipment. This
warranty is limited to defects in workmanship or materials, and does not
cover customer damage, abuse or unauthorized modification. If this
product fails or does not perform as warranted, your sole recourse shall
be repair or replacement as described above. Under no condition shall
Patton Electronics be liable for any damages incurred by the use of
this product. These damages include, but are not limited to, the
following: lost profits, lost savings and incidental or consequential
damages arising from the use of or inability to use this product. Patton
Electronics specifically disclaims all other warranties, expressed or
implied, and the installation or use of this product shall be deemed an
acceptance of these terms by the user.
1.1 SERVICE
All warranty and nonwarranty repairs must be returned freight
prepaid and insured to Patton Electronics. All returns must have a
Return Materials Authorization number on the outside of the shipping
container. This number may be obtained from Patton Electronics
Technical Support: (301) 975-1007; http://www.patton.com; or,
support@patton.com.
Notice: Packages received without an RMA number will not be
accepted.
Patton Electronics' technical staff is also available to answer any
questions that might arise concerning the installation or use of your
Model 571/581. Technical Service hours: 8AM to 5PM EST, Monday
through Friday.
1
2.0 GENERAL INFORMATION
Thank you for your purchase of this Patton Electronics product.
This product has been thoroughly inspected and tested and is
warranted for One Year parts and labor. If any questions or problems
arise during installation or use of this product, please do not hesitate to
contact Patton Electronics Customer Service at (301) 975-1007.
2.1 FEATURES
• Multi-level surge protection
• Operation at Speeds up to 100 Mbps
• Four-wire protection on lines 1, 2, 3, and 6 on Cat-5 RJ-45
• EIA/TIA TSB-40A Category 5 Compliant
• N.E.X.T. better than -43 dB at 100 MHz
• Shunts surges directly to chassis ground
• Easy to install
• Made in the U.S.A.
2.2 DESCRIPTION
Devices that connect to Category-5 cabling systems are routinely
threatened by unwanted electrical energy (lightning, AC power
induction, ESD and more). Higher speed devices–such as those
operating at 100 Mbps–are especially vulnerable to the effects of these
hazards, which can include data loss and hardware damage.
The Patton Model 571 and 581 Series Surge Protectors provide
effective surge protection for devices operating in Category-5 Cabling
Systems. The Model 571 is specifically designed for point-of-use
installation; the Model 581 is designed to be installed at the building
entrance. Both models use a multi-stage Silicon Avalanche Diode
circuit, and will continue functioning while handling the appropriate IEC
801.5 surges applicable to their use (see the tables in Appendix B).
Both the 571 and 581 will additionally protect against surges up to and
exceeding 2kV/1kA in fail-safe mode.
Models 571 and 581 support a wide range of balanced interfaces
running over 4 wires. Highlights include a low insertion loss (less than
0.4dB at 100MHz) and minimal near end cross talk (greater than -43
dB at all frequencies up to 100 MHz). Grounding is accomplished via an
external ground strap that provides a separate unit-ground to chassis-
ground connection.
Warning: This product will not provide complete protection
should your equipment or building be subject to a direct
lightning hit.
2
Advertisement
