Assembly; S-Rod Assembly; Mounting The Coil - Bounty Hunter Quick Draw II Owner's Manual

EASY ASSEMBLY
Assembling your Quick Draw ®
Detector is easy and requires no tools.
Just follow these steps:
G
1
Using the supplied bolt and knurled
knob, attach the searchcoil to the
lower stem.
G
2 Press the button on the upper end
of the lower stem and slide the
lower stem into the upper stem.
Adjust the stem to a length that
lets you maintain a comfortable
upright posture, with your arm
relaxed at your side.
G
3
Wind the searchcoil cable around
the stem. Leave enough slack in the
cable to let you adjust the coil when
you are hunting on uneven ground.
Then tighten the knob at the end of
the searchcoil.
Note:
To adjust the coil,
simply loosen the knob.
G
4
Insert the coil's plug into the
matching connector on the control
housing. Be sure the holes and
pins line up correctly.
Caution:
• Do not force the plug in.
Excess force will cause damage.
• To disconnect the cable, pull on the
plug. Do not pull on the cable.
4
II Metal
Bolt
Searchcoil
Button view
Lower
Stem
Lower
Stem
Searchcoil
Cable
Upper
Stem
TROUBLESHOOTING
Knurled
Knob
SYMPTOM
Detector chatters
or beeps erratically
Upper
Stem
Constant low tone
or constant repeating
tones
Plug
Button side
LCD does not lock
Control
Housing
on to one Target-ID
or emits multiple
tones
No power, no
sounds
Connector
on back of
control housing
TROUBLESHOOTING GUIDE
CAUSE
• Using detector
indoors
• Using detector near • Move away
power lines
• Using 2 detectors in • Keep 2 detectors
close proximity
• Highly oxidized
buried object
• Environmental
electromagnetic
interference
• Discharged batteries • Replace batteries
• Wrong type of
batteries
• Multiple targets
present
• Highly oxidized
target
• Sensitivity set
too high
• Dead batteries
• Batteries connected
improperly
• Cord not connected • Check connections
securely
SOLUTION
• Use detector
outdoors only
from power lines
at least 20' apart
• Only dig up
repeatable
signals
• Reduce sensitivity
until erratic
signals cease
• Use only 9V
alkaline batteries
• Move coil slowly
at different angles
• Reduce sensitivity
• Replace batteries
17