Mitsubishi Electric PUHZ-P100VHA.UK Service Manual page 98

OPERATING PROCEDURE
12. Removing the motor for compressor (MC)
(1) Remove the service panel. (See figure 1.)
(2) Remove the top panel. (See figure 1.)
(3) Remove 2 front cover panel fixing screws (5
remove the front cover panel. (See photo 3.)
(4) Remove 2 back cover panel fixing screws (5
remove the back cover panel.
(5) Remove the electrical parts box. (See photo 3.)
(6) Remove 3 valve bed fixing screws (4
and stop valve fixing screws (5
valve bed.
(7) Remove 3 right side panel fixing screw (5
of the unit and then remove the right side panel.
(8) Remove 3 separator fixing screws (4
the separator.
(9) Collect the refrigerant.
(10) Remove the 3 points of the motor for compressor fixing
nut using a spanner or a monkey wrench.
(11) Remove the welded pipe of motor for compressor inlet
and outlet and then remove the compressor.
Note: Collect refrigerant without spreading it in the air.
13. Removing the Accumulator
(1) Remove the service panel. (See figure 1.)
(2) Remove the top panel. (See figure 1.)
(3) Remove 2 front cover panel fixing screws (5
remove the front cover panel. (See photo 3.)
(4) Remove 2 back cover panel fixing screws (5
remove the back cover panel.
(5) Remove the electrical parts box. (See photo 3.)
(6) Remove 3 valve bed fixing screws (4
and stop valve fixing screws (5
valve bed.
(7) Remove 3 right side panel fixing screw (5
rear of the unit and then remove the right side panel.
(8) Collect the refrigerant.
(9) Remove welded pipes of Accumulator inlet and outlet.
(10) Remove 2 Accumulator leg fixing screws (4
Note: Collect refrigerant without spreading it in the air.
10) and
10) and
10) and 4 ball valve
16) and then remove the
10) in the rear
10) and remove
10) and
10) and
10) and 4 ball valve
16) and then remove the
10) in the
10).
98
PHOTOS
Photo 10
Terminal
cover
Compressor
Accumulator
Compressor
(MC)
Accumulator leg
Accumulator leg
fixing screws
fixing nut