Mitsubishi Electric PUHZ-P100VHA.UK Service Manual page 94

PUHZ-P125VHA.UK PUHZ-P140VHA.UK
OPERATING PROCEDURE
1. Removing the service panel and top panel
(1) Remove 3 service panel fixing screws (5
the hook on the right downward to remove the service
panel.
(2) Remove screws (3 for front, 3 for rear/5
panel and remove it.
2. Removing the fan motor (MF1, MF2)
(1) Remove the service panel. (See figure 1.)
(2) Remove the top panel. (See figure 1.)
(3) Remove 5 fan grille fixing screws (5
fan grille. (See figure 1.)
(4) Remove a nut (for right handed screw of M6) to detach
the propeller. (See photo 1.)
(5) Disconnect the connectors, CNF1, CNF2 on controller
circuit board in electrical parts box.
(6) Remove 4 fan motor fixing screws (5
fan motor. (See photo 2.)
3. Removing the electrical parts box
(1) Remove the service panel. (See figure 1.)
(2) Remove the top panel. (See figure 1.)
(3) Disconnect the indoor/outdoor connecting wire from
terminal block.
(4) Remove all the following connectors from controller circuit board;
fan motor, linear expansion valve, thermistor <Outdoor pipe>,
thermistor <Discharge>, thermistor <Outdoor 2-phase pipe>,
thermistor <Outdoor>, high pressure switch, solenoid valve
coil <Four-way valve>.
Then remove a screw (4
the lead wire.
Pull out the disconnected wire from the electrical parts box.
<Diagram symbol in the connector housing>
• Fan motor (CNF1, CNF2)
• Linear expansion valve (LEV-A)
• Thermistor <Outdoor pipe> (TH3)
• Thermistor <Discharge> (TH4)
• Thermistor <Outdoor 2-phase pipe, Outdoor> (TH6/7)
• High pressure switch (63H)
• Solenoid valve coil <Four-way valve> (21S4)
(5) Remove the terminal cover and disconnect the
compressor lead wire.
(6) Remove an electrical parts box fixing screw (4
detach the electrical parts box by pulling it upward. The
electrical parts box is fixed with 2 hooks on the left and 1
hook on the right.
10) and slide
10) of the top
10) to detach the
25) to detach the
8) from the valve bad to remove
10) and
PHOTOS & ILLUSTRATION
Top panel fixing screws
Figure 1
Grille
fixing
screws
Grille
fixing
screws
Photo 1
Front panel
Propeller
Nut
Photo 3
Controller circuit board
(C.B.)
Screw
Cover panel fixing screws
94
Top panel
Service panel
Slide
Fan grille
Service panel
fixing screws
Photo 2
Fan
Fan motor fixing screws
motor
Fan motor fixing screws
Electrical
parts box
Electrical parts
box fixing screw
Terminal block
(TB1)
Valve bed
Motor for
compressor
(MC)
Terminal cover
Cover panel
(Front)