Mounting Of Handle - Makita EBH340U Instruction Manual

MOUNTING OF HANDLE For BH3600

MOUNTING OF HANDLE

– Place the handle with the throttle lever on the handle
holder on the right side (to be held by the right hand) and
the other on the left side.
– Fit the handle edge to the handle holder groove, and
provisionally fix the upper side (3) of the handle holder by
four bolts M5 x 25 (4).
– Adjust the handle to an angle easy to manipulate, and
tighten the bolt (4) uniformly on the right and left sides.
– Fix the control cable to the shaft by two clips (5).
– Fix the control cable to the handle by clip (6).
– The purpose of the detent lock is to prevent the engine
from rotating relative to the drive shaft while operating the
starter or transporting the equipment from place to place.
The detent should be unlocked while the unit is being
used.
12
(4)
(3)
(6)
Detent lock
(5)
Hanger
UNLOCK
LOCK