Assembly Of Engine And Shaft; Mounting Of Handle - Makita RBC411U Instruction Manual

ASSEMBLY OF ENGINE AND SHAFT

CAUTION: Before doing any work on the brushcutter, always switch off the motor
and pull the spark plug connector off the spark plug.
Always wear protective gloves.
CAUTION: Start the brushcutter only after having assembled it completely.
– After checking the parts, fasten the drive shaft to the engine with four bolts
M6 x 22 (1). At this time, fasten also the earth terminal (2) of the stop cord to the
engine.

MOUNTING OF HANDLE

– Place the handle with the throttle lever on the handle holder on the right side (to
be held by the right hand) and the other on the left side.
– Fit the handle edge to the handle holder groove, and provisionally fix the upper
side (3) of the handle holder by four bolts M5 x 25 (4).
– Adjust the handle to an angle easy to manipulate, and tighten the bolt (4)
uniformly on the right and left sides.
– Mount the waist pad (5). When the waist pad is mounted, be sure to confirm that
the wires do not move horizontally.
– Avoid any tendency of the throttle wire to loop at the handle bar.
The purpose of the detent lock is to prevent the engine from rotating relative to
the drive shaft while operating the starter or transporting the equipment from
place to place. The detent should be unlocked while the unit is being used.
9
(4)
(3)
Hanger
Detent lock
Throttle wire