Mounting Of Cutter Blade - Makita EBH340U Instruction Manual

MOUNTING OF CUTTER BLADE

Turn the machine upside down, and you can replace the
cutter blade easily.
– Insert the hex wrench through the hole in the gear case
and rotate the receiver washer (4) until it is locked with
the hex wrench.
– Loosen the nut (1) (left-hand thread) with the socket
wrench and remove the nut (1), cup (2), and clamp
washer (3).
Mounting of cutter blade
With the hex wrench still in place.
– Mount the cutter blade onto the shaft so that the guide of
the receiver washer (4) fits in the arbor hole in the cutter
blade. Install the clamp washer (3), cup (2), and secure
the cutter blade with the nut (1).
[Tightening torque: 13 - 23 N m]
NOTE: Always wear gloves when handling the cutter blade.
NOTE: The cutter blade-fastening nut (with coned disc
spring) is a consumable part.
If there appears any wear or deformation on the
coned disc spring, replace the nut.
– Make sure that the blade is the left way up.
Rotation
15
(4)
(1)
(2)
(3)