Electronic Operation - Cal Spas Pneumatic Series Owner's Manual

Owner's Manual

1100 Electronic Operation

1100 ELECTRONIC OPERATION
Figure 14. 1100 Electronic Control Panel
Temperature Adjustment (Range 80°F to 104°F)
The display screen will always display the actual water temperature.
Example: The actual water temperature is 100°F, the topside display will read 100.
To display the set temperature, simply depress the Temp pad and the temperature setting will flash on and off on
the display panel. While the display is flashing, each time you depress the Temp pad the set temperature will
increase one degree. Allow the display to revert back to the actual water temperature, then depressing the Temp
pad again, allows you to decrease the set temperature by one degree with each press of the Temp pad.
Standard Heating Mode
Your new spa is equipped with a "Standard Heating Mode" feature that gives you complete control of the
heating system. When the spa is powered up, the heating system will automatically activate. Whenever the water
temperature drops more than one degree below the set temperature, the heating system will automatically
activate and continue to operate until the spa has regained the temperature loss.
Jet / Light Controls
Depress the Jets pad once to activate the spa light.
Depress the pad a second time to activate the spa light and the low speed pump.
Depress the pad a third time to activate the spa light and the high-speed pump.
Depress the pad a fourth time to run the high-speed pump with the spa light off.
Depress the pad a fifth time to turn off the high-speed pump.
Automatic Time outs
The low-speed pump will automatically turn itself off after 30 minutes, if it's not turned off manually.
The high-speed pump will automatically turn itself off after 30 minutes, if it's not turned off manually.
The spa light will automatically turn itself off after 4 hours, if it's not turned off manually.
Revised 01/01/04 Page 23