Operating Your Spa; Electronic Control Operation - Cal Spas LTR20091058 Owner's Manual

6

Operating Your Spa

Electronic Control Operation

Initial Start up
When first powered up, your spa will perform a self-diagnostic check and to into priming mode. The topside will
display PR to indicate this. Priming mode will be active for less than five minutes. When the spa has finished
priming, the heater will be activated and the water temperature will be maintained in standard mode. The spa
will heat to 100°F (37.5°C) at start up until the set temperature is changed as described below.
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The electronic control panel displays the ac-
tual water temperature in degrees Fahren-
heit. The displayed temperature will only be
current after the pump has been running for
at least two minutes.
To display the temperature that the spa is
set to:
• Press either the
perature setting will flash.
• While the display is flashing, each time you press
the Up or Down button, the set temperature will
change up or down one degree.
Standard, Economy and Sleep Heating
Modes
Your new spa is equipped with a heating feature that
gives you complete control of the heating system.
When the spa is powered up, it will automatically start
in standard heating mode.
• St will light briefly on the main display. In this
mode, the heating system will automatically main-
tain the set spa temperature. In the economy-
heating mode, the heating system will only acti-
vate during filtration times.
• Ec will display solid if temperature is not current
and will alternate with spa temperature if mea-
sured temperature is current.
• Economy mode will heat the water to the set tem-
perature while Sleep mode, indicated by a SL on
the main display, will also only activate the heater
during the filtering cycles but will only heat the
water to within 20°F (10°C) of the set tempera-
ture. Like Economy mode, SL will display solid
when temperature is not current and will alternate
with actual temperature when it is current.
www.calspas.com
Up or Down button. The tem-
Switching Modes
Up or Down button followed by
• Press either the
the Light button.
• Press the same sequence to switch to the next
mode.
Jets
Press the Jets button:
• Once to activate low speed pump.
• Twice to activate high speed.
• Three times to turn pump off.
Light
Press the Light button to turn on the light. Press it
once again to turn the light off. All optional lighting
such as the control panel light and cabinet perimeter
lighting is controlled by the Light button and will turn
on and off with the spa light.
Automatic Time outs
These features will automatically turn themselves off
during periods of continuous use:
• Low speed pump
• High speed pumps
• Spa light
After 2 hours
After 15 minutes
After 4 hours
2009 Genesis Portable Spa
LTR20091058, Rev. B