2.3 Factory Default Settings
Before configuration, please refer to following default settings,
Web interface:
Username: admin
Password: 1234
LAN IP Settings:
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
DHCP:
DHCP Server: Enable
3.0 Hardware Requirements
To use WLAN ADSL2+ Router, please have following hardware / accessories ready.
A PC with Pre-installed Ethernet Adapter (Required)
12Vac power adaptor (Included in the package)
RJ-45 Ethernet cable (Included in the package)
RJ-11cable (Included in the package)
3.1 Setting up the Hardware Environment
Be sure that you are well insulated from any power
Note!
source to avoid electricity shock.
Please kindly refer to chapter 4.0 "Installation & Setup"
3.2 Powering on WLAN ADSL2+ Router
Use only the manufacturer-approved power supply that
Note!
shipped with the WLAN ADSL2+ Router.
1. Connect the power to the WLAN ADSL2+ Router by plugging the power
supply into an appropriate electrical outlet.
2.
If the Power LED is off, refer to "Troubleshooting" for information.
Please kindly refer to chapter 4.0 "Installation & Setup"
Important Notice!
For software installation, please refer to the file inside your CD.
CD ROM :\MANUAL\Manual.pdf.
WLAN ADSL2+ Router
5