Assembling And Hanging The Fan - Hunter 42507-01 Installation And Operation Manual

3 • Assembling and Hanging the Fan
Steps 3-1 – 3-2

Loop
Step 3-4
Hunter Fan Company
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Downrod
You can assemble your fan for standard or angle mounting as shown
in steps 3-1 – 3-4. For low profile mounting (ceilings less than 8 feet
high), go to steps 3-5 – 3-11 on the next page.
Canopy
For Standard or Angled Mounting:
3-1. Unbundle the wires from the fan.
Canopy
3-2. To assemble fan to hang down from a flat or angled ceiling, insert
Trim Ring
the downrod through the canopy and canopy trim ring. Feed the
Set Screw
wires from the fan through the downrod.
3-3. Loosen the square head set screw on the adapter to install the
pipe and ball assembly. Note: When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
normal. Securely retighten the set screw with a wrench or pliers.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
3-4. Raise the fan and place the hook on the downrod through the
loop on the ceiling plate. The arrows on the downrod and on the
Downrod
ceiling plate should both be pointing towards the tab hole on the
with Hook
canopy. Go to 4 • Wiring the Fan.
42507-01 • 02/26/07