10.1.1 Repairing punctures (pneumatic tires of type 4.00 - 5)
10.1.1.1 Removing the rear wheel
Requirements:
• Open wrench, 19 mm.
• Rubber hammer
•
Jack the scooter up and place a wooden block or similar
under it to support it.
•
Remove the wheel locknut (1) with a 19 mm open-ended
wrench.
•
Remove the wheel. It may be necessary to carefully free the
wheel off the axle by tapping lightly with the rubber hammer
on the rear face of the wheel
Problems when removing wheel?
It may be necessary to use a special tool Please ask your Invacare Canada dealer to help you.
Reassembly
Reassembly takes place in reverse order.
Make sure that you refit the wheel on the same side and for the same direction of travel as
previously.
51