The Direct Vent System; Section 3-1: Converting From Top Vent To Rear Vent - Montigo L52DF Installation & Maintenance Manual

Montigo supplies a variety of direct venting and termination options.
The direct vent termination location MUST be selected such that
it is the highest point in the venting assembly. It should also be
selected such that it provides the shortest vent run possible. Should it
be impossible to ensure that the termination is the highest point or to
meet the venting guidelines laid out below please contact your Montigo
dealer to discuss power venting options.
NOTES FOR PLANNING VENTING:
Venting can originate from the unit through the top or through the rear
Venting can terminate through the roof or through an exterior wall.
Refer to Appendix A - Termination Locations to ensure the planned
termination location is acceptable.
Once the termination location has been established, refer to the
appropriate section below for installation details
All fireplaces shipped from the factory are Top vent.
See Section 3-1 for converting the unit from top vent to rear vent.
Section 3-1:
CONVERTING TO REAR VENT
Use the following instructions to convert an L52DF* for Rear Vent use:
1. Remove the Rear flue cover and gasket (5" and 8") on the flue
outlet, as shown in Figure 7.
2. Next, Remove the Top flue collar's (5" and 8") on the flue outlet,
as shown in Figure 7.
3. Install the (removed) Rear flue cover and gasket material, to the
Top vent outlet. Fasten the cover with included hardware, as
illustrated Figure 8.
4. Install the (5" and 8") collars to the rear vent outlet using the
Flue Gasket
Flue Cover Plate
Figure 7. Flue cover and collar removal, Top Vented
fireplace.
XG0185 - 050611
Installation
8" Outer Flue Collar
5" Inner Flue Collar
Figure 8. Flue cover and collar installation, Rear Vented
fireplace.
5" Inner Flue Collar
8" Outer Flue Collar
L52DF* Indoor Gas Fireplace
included hardware, as illustrated Figure 8.
Section 3: Venting
Flue Cover Plate
Flue Gasket
Page 7