Select Shock Setting; Setting Parking Brake - BOB Gear REVOLUTION Instruction Manual

SELECT SHOCk SETTING

1. Remove Child From Seat
2. Set Shock Setting To Position 2
Depress shock release knob and
simultaneously pull toward back of
stroller, sliding knob into position 2.
Knob will "snap" into place when in
correct position.
REPEAT on opposite side.
Position 1: Child 40 pounds or less
SNAP
Position 2: Child 41 to 70 pounds
SNAP
NOTE: Every time stroller is folded,
stroller shocks default to position 1.
14
UGA08C
40 lbs
70 lbs
41 lbs

SETTING pARkING BRAkE

The parking brake prevents the
stroller from moving while loading
and unloading. The parking brake is
not designed as a stopping brake.
IMpORTANT: Do not park on
inclines. The parking brake is
intended to park the stroller on flat
surfaces only. Parking on inclines
may result in tip over or runaway
stroller.
To set the parking brake, press down
on the red foot pedal – making sure
the locking pin fully engages the
locking disk.
LOCKED POSITION
To ensure the brake is set properly,
attempt to roll the stroller forward and
backward after setting the brake. If
the stroller will not roll, the brake is set
properly.
To release the parking brake, lift up
on the red foot pedal with your foot
until the brake bar springs up into
the fully unlocked position.
UNLOCKED POSITION