Vent Diagrams - Heat & Glo RED60 Owner's Manual

I. Vent Diagrams
Fire Risk. Explosion Risk.
Do NOT pack insulation or other combustibles between ceiling fi restops.
• ALWAYS maintain specifi ed clearances around venting and fi restop systems.
• Install wall shield and ceiling fi restops as specifi ed.
Failure to keep insulation or other material away from vent pipe may cause fi re.
Top Vent - Horizontal Termination
Venting with 1 elbow
V Minimum V
1 1
2 ft. 610 mm 60 ft.
3 ft. 914 mm 70 ft.
4 ft. 1.2 m 80 ft.
V + H = 80 ft. (24.4 m) Maximum
1 1
WARNING! Risk of fi re and burns!
DO NOT install PVI-DVP with the
access panel facing upward. Over-
heating may occur.
Figure 7.21
30
+ H Maximum
1
18.3 m
21.3 m
24.4 m
Heat & Glo • RED60 • 2159-900 Rev. B • 12/09
WARNING
Note: Must have 24 inches minimum
vertical vent prior to attaching any
elbow to the appliance.
Note: PVI-DVP can be located in any
position except V
1.
H
1
Note: Use DVP Series
components only.
V
1