How To Change Or Rotate Brushes On Cylindrical Brush Head - Clarke Focus Operator's Manual

ENGLISH
EN
How To Prepare the Machine For Operation
How To Change or Rotate Brushes on Cylindrical
Brush Head
To install or rotate brushes on the cylindrical brush head:
1. Raise the brush deck and turn the key switch
"OFF".
2. Raise the brush skirt and pull out to remove. See
figure 11.
3. Remove thumb screw from brush door. See figure
12.
4. Lower door approximately 1/2 inch and slide door
and hub assembly from brush. See figure 13.
5. Slide brush off hub at opposite end. See figure 14.
6. Rotate brush or replace.
7. Slide brush on drive hub and insert door and hub
assembly into brush core.
8. Raise door and install thumb screw.
9. Place side skirt on retainer pins and lower in place.
10. Brushes should be rotated after every 20 hours of
use.
Page -14-
Figure 11
Figure 12
Figure 13
Figure 14
Clarke ®
Operator's Manual (EN) - Focus Rider