Desciption Of Function & Circuit Of Micom - Kenmore 795.71042.01 Service Manual

13. DESCRIPTION OF FUNCTION & CIRCUIT OF MICOM
13-1 FUNCTION
13-1-1 Function
1. When the appliance is plugged in, it defaults to 37°F for the refrigerator and 0°F for the freezer.
You can adjust the refrigerator and the freezer control temperature by pressing the ADJUST button.
2. When the power is initially applied or restored after a power failure, it is automatically set to 3 & -18.
Basic Model
Control range : 33°F ~ 46°F
1°C ~ 8°C
13-1-2 How to Change the Temperature Mode to °F/°C
1. The display temperature mode can be changed from °F to °C or °C to °F by pressing and holding the FRZ TEMP and the
REF TEMP keys at the same time for over five seconds.
13-1-3 EXPRESS FREEZING
1. The purpose of this function is to intensify the cooling speed of freezer and to increase the amount of ice.
2. Whenever selection switch is pressed, selection/release, the icon will turn ON or OFF.
3. If there is a power outage and the refrigerator is powered on again, EXPRESS FREEZING will be canceled.
4. To activate this function you need to press the EXPRESS FREEZING key and the icon will turn ON. This function will
remain activated for 24 hours.
13-1-4 How to s et the dis play mode and cancel it
1. Keep pressing FRZ Temp button and the Ref Temp button for 5 seconds at the same time with opening the refrigerator
door.
2. It goes to display mode with special indication as below figure
3. All freezing unit will be turned off at display mode(Exceptions : Lamp, Display)
4. To cancel display mode, keep pressing refrigerator or freezer temperature adjust button to higher more then 5 seconds
Display Mode
13-1-5 REFRIGERATOR LAMP AUTO OFF
1. To protect the risk of lamp heat, when the refrigerator door is opened for 7 minutes, the refrigerator lamp will be turned off
automatically.
- 54 -
Control range : -6°F ~ 8°F
-21°C ~ -13°C