Lamp; Multi Duct; Main Pwb - Kenmore 795.71042.01 Service Manual

3-6 LAMP

Unplug Refrigerator, or disconnect power at the circuit
breaker.
If necessary, remove top shelf or shelves.
3-6-1 Refrigerator Compartment Lamp
1) Release 2 screws.
2) Hold both ends with your both hands and pull it
downward to remove it.
3) To remove the case lamp and cover lamp, release
another 2 screws as following picture.
3) Use a flat blade screwdriver as shown below to remove
the cover lamp.
4) To remove the LED Assembly, open the Hook part to pull
it out as shown in the following picture.
Cover, lamp LED, Assembly
3-6-2 Freezer Compartment Lamp
1. Unplug refrigerator power cord form outlet.
2. Remove screw with driver.
3. Grasp the cover Lamp,pull the cover downward.

3-7 MULTI DUCT

1. Remove the upper and
lower Caps by using a
flat screwdriver, and
remove 2 screws.
(Figure 3)
2. Disconnect the lead wire
on the bottom position.

3-8 MAIN PWB

WARNING : Unplug the refrigerator before removing the
control board.
1) Loosen the 3 screws on the PWB cover.
2) Remove the PWB cover
Case, lamp
3) Disconnect wire harness and replace the main PWB in
the reverse order of removal.
- 9 -
Figure 3