Philips HQ8290CC User Manual page 15

After the cleaning program, the battery symbol on the Jet Clean
,
System goes on to indicate that the shaver is being charged.
Note: If you press the on/off button of the Jet Clean System during the
cleaning program, the program aborts and resets. In this case, the cleaning or
drying symbol stops flashing and the holder returns to its starting position.
The shaver may still be wet and dirty, because the cleaning program has not
been finished.
Note: If you remove the adapter from the wall socket during the cleaning
program, the program aborts. The holder remains in its current position. When
you put the adapter back into the wall socket, the holder moves to the
highest position.
- When the fluid level drops below the minimum level, the cleaning
symbol and the 'fluid low' symbol start to flash with intervals and the
holder returns to its starting position (Fig. 21).
Cleaning the Jet Clean system
Empty the cleaning chamber and clean it thoroughly by rinsing it with hot
tap water every 15 days if you use the Jet Clean System daily. Otherwise
empty and clean the cleaning chamber at least once a month.
1 Clean the outside of the Jet Clean System with a moist cloth.
Never immerse the Jet Clean System in water nor rinse it under the
tap.
2 Simultaneously press the release buttons on both sides of the Jet
Clean System (1). Then lift the Jet Clean System off the cleaning
chamber (2). (Fig. 22)
The cleaning chamber remains behind.
,
3 Pour any remaining cleaning fluid out of the cleaning
chamber. (Fig. 28)
You can simply pour the cleaning fluid down the sink, this is not harmful
to the environment.
4 Rinse the cleaning chamber under a hot tap (Fig. 29).
Be careful with hot water. Always check if the water is not too hot, to
prevent your hands from getting burnt.
EnglisH
17