Philips HQ8290CC User Manual page 13

3 After trimming, close the trimmer ('click') and switch off the
shaver (Fig. 20).
Cleaning and maintenance
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the shaver and the Jet Clean System.
- Clean the shaver after every shave for optimal shaving performance.
- The best and most hygienic way to clean the shaver is in the Jet Clean
System. You can also rinse the shaver under the tap or clean it with
the brush supplied.
- Be careful with hot water. Always check if the water is not too hot, to
prevent your hands from getting burnt.
- You can clean the outside of the shaver with a damp cloth.
Note: Water may leak from the socket at the bottom of the appliance when
you rinse it. This is normal and not dangerous.
Cleaning the shaving unit in the Jet Clean system
The Jet Clean System cleans the shaving unit.
Preparing the Jet Clean system for use
- Fill the cleaning chamber before first use and when the 'fluid low'
symbol flashes to indicate that the fluid level is too low. When the
fluid level drops below the minimum level, the cleaning symbol and
the 'fluid low' symbol start to flash with intervals and the holder
returns to its starting position. (Fig. 21)
1 Simultaneously press the release buttons on both sides of the
cleaning chamber (1). Then lift the Jet Clean System off the cleaning
chamber (2). (Fig. 22)
The cleaning chamber remains behind.
,
2 Unscrew the cap from the bottle with HQ200 cleaning fluid and
remove the airtight seal.
3 Fill the cleaning chamber with HQ200 cleaning fluid up to the MAX
indication (Fig. 23).
EnglisH
15