BBQ GSC3219TA Owner's Manual page 9

Step 3
a) Loosen the two pre-installed bolts
on the end of front beam (J) and
allow 1/4 bolt's length to extend from
the front beam. Align the two holes
on the cart side panel with the two
bolts extended from the end of front
beam. Push down the front beam
until it locks into place
b) Align the two holes on the side of
front beam with the holes on the
side frame of cart side panel.
c) Insert one bolt (AA) with one flat
washer (CC) and one spring washer
(DD) into each pre-drilled hole.
d) Repeat the procedure a) for the
back beam (E).
e) Loosen the four pre-installed bolts
on the back of cart side panels and
allow 1/4 bolt's length to extend from
the cart side panels.
f) Align the four holes on the cart back
panel (G) with the four bolts
extended from the cart right side
panel and cart left side panel.
g) Push down the cart back panel until
it locks into place. Tighten bolts by
hand until secure.
h) Go back and tighten all bolts using
the screwdriver provided.
Step 4
a) Align the holes on the end of
drawer left support (H) with the
holes on the left end of front beam
and back beam.
b) Insert one bolt (EE) with one flat
washer (FF) and one spring
washer (GG) into each pre-drilled
hole.
c) Tighten bolts by hand until secure.
d) Repeat the procedure for the
drawer right support (K) and the
right end of front beam and back
beam.
e) Go back and tighten all bolts using
the screwdriver provided.
M4×15 bolt
EE
M4 spring washer
GG
M4 flat washer
FF
GSC3219TA
Owner's Manual
8 PCS
8 PCS
8 PCS
AA
CC
DD
8
M6×30 bolt 2 PCS
M6 flat washer 2 PCS
M6 spring washer 2 PCS