BBQ GSC3219TA Owner's Manual page 12

Step 9
a) Put the body assembly (B) on
the top of cart assembly.
b) Align the two holes on the left
top of cart assembly with the
two holes on the left of body
assembly.
c) Insert one bolt (BB) with one
flat washer (CC) and one
spring washer (DD) into each
pre-drilled hole.
d) Tighten bolts by hand until
secure.
e) Repeat the procedure for the
right top of cart assembly.
f) Go back and tighten all bolts
using the screwdriver
provided.
M6×15 bolt
BB
M6 flat washer
CC
M6 spring washer
DD
Step 10
a) Loosen the three pre-installed bolts on
the left side of body assembly and
allow 1/4 bolt's length to extend from
the left side of body assembly.
b) Align the holes on the left side shelf (A)
with the bolts extended from the left
side of body assembly.
c) Push down the left side shelf until it
locks into place. Tighten all bolts using
the screwdriver provided.
d) Align the hole on the right side of the
left side shelf (A) with the hole on the
left side of control panel .
e) Insert one bolt (BB) with one flat
washer (CC) and one spring washer
(DD) into each pre-drilled hole. (See
diagram to right)
f) Align the hole on the right side of the
left side shelf with the hole on the left
side of body assembly.
g) Insert one bolt (AA) with one flat
washer (CC) and one spring washer
(DD) into each pre-drilled hole towards
into the body assembly.
h) Repeat the procedure for the right side
shelf (S) and the right side of body
assembly .
i) Go back and tighten all bolts using the
screwdriver provided.
GSC3219TA
Owner's Manual
4 PCS
4 PCS
4 PCS
M6×30 bolt
AA
M6×15 bolt
BB
M6 flat washer
CC
M6 spring washer
DD
11
2 PCS
2 PCS
4 PCS
4 PCS