Preparation - Fujitsu ABY30TL MA Operating Manual

PREPARATION

Set the Current Time and Day
1 Press the CLOCK ADJUST button for more than three
seconds.
2 Press the SET TEMP./DAY button and set the day.
▲: Use to advance the day forward.
▼: Use to turn the day back.
The day is indicated by a code number from 1 to 7, as shown in the table
below. Set to the number that corresponds to the current day.
DAY CODE
DAY OF THE WEEK
3 Press the SET TIME button and set the time.
▲: Use to advance the time forward.
▼: Use to turn the time back.
(Press once to move the time 1 minute; hold down and the time will move
10 minutes at a time.)
4 Press the CLOCK ADJUST button again.
This registers the new day and time values. The day display goes off, and
the time display stops flashing.
En-6
1 2 3 4
MON TUE WED THU
5 6 7
FRI SAT SUN
Example: Set the time to 9:31.
CLOCK AUTO
DAY
1 2
TIMER SET TIME TEMP./DAY FAN
MODE CONTROL
CLOCK ADJUST
2
3
1
SET DAY OFF
CLOCK
1 2
AUTO
DEFROST TEST
MASTER
CONTROL
START/STOP