Stacking Instructions - GE Spacemaker DSXH43 Owner's Manual

Stacking instructions.

WARNING
To reduce the risk of electric shock, disconnect
this appliance from the power supply before
attempting any user maintenance. Turning the
controls to the OFF position does not disconnect
this appliance from the power supply.
Tools and Materials Required for Stacking the Dryer
Phillips head screwdriver
Channel-lock adjustable pliers
Mounting the Dryer to the Washer
The numbers in the illustration correspond to steps.
Remove the washer top panel by first removing
1
the 4 screws in the 2 brackets located on the top
rear of the washer.
Slide the top forward, lift the front of the top up,
and remove the top panel.
Remove the 2 brackets from the rear of the top
panel.
Using the 4 screws that were removed in step 1,
2
install the brackets in the rear support as shown.
Remove the 4 screws and the 2 long front
3
brackets located on the top front of the washer.
Install the 2 new front mounting brackets
4
provided and the 4 screws that were removed in
step 3. Note that the tab of the front mounting
bracket is facing forward as shown in the
illustration.
18
Refer to the washer and dryer installation
instructions prior to stacking appliances.
Reading all of the information contained in
these instructions will simplify the installation
and ensure a correct and safe operation. A fire
hazard and/or personal injury could result from
improper installation.