Stacking Instructions - GE DCCH480EK Technical Service Manual

The GE dryer is designed to allow placement
(stacking) on top of certain GE front-loading
washers. Washer models that currently qualify are:
• WCVH4800K
• WCVH4815K
Note: If you are planning to stack the washer and
dryer, order Stacking Kit number GE24STACK to be
used for this dryer. Kit sold separately.
• IMPORTANT – Save these instructions for local
electrical inspector's use.
• IMPORTANT – Observe all governing codes and
ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Stacking installations may require a power cord
up to six feet in length.

Stacking Instructions

• Make sure the dryer is unplugged.
• More than 2 people are recommended to safely
lift the dryer into position.
• Avoid damage to the existing utility services.
• DO NOT place the washer on top of the dryer.
Location Requirements
When installed in a location other than an alcove
or closet, the minimal clearances to combustible
surfaces and for air opening are: 0 inches on both
sides, and 3 inches front and rear. Consideration
must be given to provide adequate clearance for
installation and service.
Note: Your dryer is approved for installation in an
alcove or a closet, as stated on a label on the dryer
back.
When installed in an alcove or closet:
• Minimum clearance between dryer cabinet
and adjacent walls or other surfaces is 0 inches
either side, and 3 inches front and rear.
• Minimum vertical space from fl oor to overhead
shelves, cabinets, ceilings, etc., is 67.7 inches.
• Closet doors must be louvered or otherwise
ventilated and have at least 60 square inches
of open area equally distributed. If the closet
contains both a washer and a dryer, doors must
contain a minimum of 120 square inches of
open area equally distributed.
– 16 –
WARNING!
(Continued Next Page)