Operation; General; Autopilot Mode; Adjusting Course - Simrad TP10 User Manual

Tillerpilots
Hide thumbs Also See for TP10:
Table of Contents

Advertisement

2
TACK
STBY
STBY
AUTO
¼ Note:
NAV
TACK
STBY
STBY
AUTO
NAV
TACK
STBY
STBY
AUTO
NAV
¼ Note:

Operation

General

The unit powers up in Standby mode indicated by a flashing LED
STBY/AUTO
next to the
( ) and Starboard ( ) keys are always dimly lit, which provides
night illumination for the keypad. All functions are confirmed
audibly by a "beep" and visually by the LEDs, so the status of the unit
can always be confirmed at a glance.
NAV
The
key on the TP22 and TP32 is labeled
TP10. Both keys are referenced where applicable.

Autopilot mode

While in Standby mode, the pushrod can be manually driven in and
out by pressing the arrowed Port ( ) and Starboard ( ) keys, which
allows "power steering" of the vessel.
To engage Autopilot mode, press the
Tillerpilot will lock onto the current course. The LED next to this key
will stop flashing and remain permanently lit as long as the pilot is
in Autopilot mode.
To lock the pilot onto the desired course, either steer the correct
course and then engage the autopilot, or engage the autopilot and
then adjust the heading until the correct course is being sailed (see
"Adjusting course" on page 5).
STBY/AUTO
If the
second time and lock onto the previously used heading (this feature
will not be available if the unit has just been switched on).

Adjusting course

In Autopilot mode, precise course adjustments can be easily made:
-
Press the Port ( ) or Starboard ( ) key once and a 1º course
adjustment will be made in the specified direction. This is
confirmed by a single beep and the Port or Starboard LED will
flash once.
-
Press and hold either key and a 10º course adjustment will be
made, confirmed by a double beep and a double flash of the Port
or Starboard LED.
Following any course adjustment in Nav mode (see "Nav
mode" on page 7), the Tillerpilot will gradually return to the
navigation track.
Operation |
TP10, TP22 & TP32 User Guide
key. The two direction LEDs above the Port
STBY/AUTO
key is pressed and held, the pilot will beep a
CAL
on the
key and the
| 5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tp32Tp22

Table of Contents