Configuring The Tp On The Simnet Bus - Simrad TP10 User Manual

Configuring the TP on the SimNet bus

Normally the TP22 and TP32 can be connected to the SimNet bus
and will automatically share data sources with other SimNet units
without any required user intervention.
Display
Two operation modes are available:
System mode (default)
StandAlone mode
-
To change the mode, first turn off the Tillerpilot
-
To select StandAlone mode, press and hold the
and turn the power on
-
To select System mode, press and hold the
turn the power on
-
The Tillerpilot will beep and all the LEDs will light briefly to
confirm the new configuration
¼ Note:
Please refer to the instructions supplied with the relevant
command unit for details on remote configuring of data sources.
Installation | TP10, TP22 & TP32 User Guide
Autopilot
Compass
The Tillerpilot automatically shares data
with other SimNet units.
Source selection can be done from any
SimNet unit using shared data resources
The Tillerpilot is disconnected from
SimNet, and it will automatically
select its internal heading sensor. The
Tillerpilot cannot be configured by a
remote device.
GPS/Chartplotter
TACK
and keys
TACK
and keys and
| 17