Configuration; Porthand Mounting; Calibration Mode - Simrad TP10 User Manual

4
TACK
STBY
STBY
AUTO
NAV
POWER ON
TACK
TACK
STBY
STBY
AUTO
NAV
TACK
STBY
STBY
AUTO
NAV

Configuration

Porthand mounting

Although the Tillerpilot is factory preset for Starboard-side
mounting, it is possible to reconfigure it for mounting on the Port-
side of the cockpit to facilitate easy installation on most types of
yacht.
Starboard and Port mounting options
With the power off, hold down the
switch on the power. The Port or Starboard LED will illuminate,
depending on the current mounting configuration. Press the
( ) key to select Port-side mounting – the Port LED will illuminate to
indicate selection. Confirm selection and exit to Standby mode by
NAV
pressing (CAL).
To select Starboard mounting, repeat the above procedure, but
STArBOArd
press the

Calibration mode

The Response Control level and Seastate setting can be adjusted
while the Tillerpilot is in either Standby or Autopilot mode:
-
Press and hold the
-
The Starboard LED will illuminate to indicate that Response
Control adjustment is selected. To toggle between Response
Control and Seastate adjustment, press
illuminate for Seastate.
Configuration | TP10, TP22 & TP32 User Guide
NAV
( ) key.
TACK
key, then press
TACK
(CAL) and keys and
NAV
(CAL)
TACK
– the Port LED will
POrT
| 9