Installation Procedure - Columbia CEG-C Installation, Operation & Maintenance Manual

Ceg-c series gas fired boilers for steam heating

Hide thumbs Also See for CEG-C:

Installation manual and operating instructions (28 pages)

Table Of Contents

Table of Contents

Improper installation, adjustment,

alteration, service or maintenance can

cause injury.

• The installation must conform to the requirements

of the authority having jurisdiction or, in absence

of such requirements, to the latest revision of the

National Fuel Gas Code, ANSI Z223.1/NFPA 54.

Reference should also be made to local gas utility

regulations and other codes in effect in the area

that the installation is to be made.

• Where required by the authority having

jurisdiction, the installation must conform to the

Standard for for Controls and Safety Devices For

Automatically Fired Boilers, ANSI/ASME CSD-1.

• This boiler is classiﬁ ed as a Category I appliance

and the vent installation shall be in accordance

with "Venting of Equipment" of the National Fuel

Gas Code noted above or applicable provisions of

the local building codes. See Vent Installation on

page 8.

• This boiler meets safe lighting and other

preference criteria with the gas manifold and

control assembly provided on the boiler per the

latest revision of ANSI Z21.13.

• This boiler shall be installed such that the gas

ignition system components are protected from

water (dripping, spraying, rain, etc.) during

appliance operation and service, (circulator

replacement, condensate trap, control

replacement, etc.).

• LOCATE BOILER on level, solid base as near

chimney as possible and centrally located with

respect to the heat distribution system as

practical.

• ALLOW 24 inches at the front and right side for

servicing and cleaning.

• When installing in a utility room, the door should

be wide enough to allow the largest boiler part

to enter, or to permit replacement of another

appliance such as a water heater.