Rear Fog Lamps - Chevrolet 2012 Malibu Owner's Manual

A. Brake lamp/Tail lamp
B. Indicator Lamp
Notice: Improper lamp assembly
removal and installation can
cause leaks and water intrusion
which may cause damage to the
tail lamp. Do not remove the tail
lamp assembly to replace a bulb.
Use the boot opening to access
the bulb.
To replace any one of these bulbs:
Brake lamp/Tail lamp and
Indicator Lamp
1. Open the boot. See Boot on
page 1‑11.
2. Remove the push pins and pull
the boot trim away from the tail
lamp assembly.
3. Remove the bulb socket from
the tail lamp assembly by turning
it anticlockwise.
4. Remove the bulb from the
socket by turning the bulb
anticlockwise one-quarter turn
and pulling it straight out.
5. Install a new bulb into the
socket.
6. Install the bulb socket into the
tail lamp assembly by turning it
clockwise.
7. Install the boot trim and
push pins.
Vehicle Care

Rear Fog Lamps

1. Locate the bulb assembly under
the rear fascia.
2. Remove the bulb socket by
turning it anticlockwise and
pulling it straight out of the
assembly.
3. Remove the bulb by turning it
anticlockwise.
4. Install the new bulb by turning it
clockwise into the socket.
5. Install the socket by turning it
clockwise into the lamp
assembly.
9-35