Table of Contents
Advertisement
Normal procedure:
Let go of the throttle lever and wait until the
engine has changed to idling speed. Then set
the ON/OFF switch to "Stop" or "0".
6.4 Practical tips
Never allow the machine to run at low speed for
starting or for cutting.
Cutting for dense growth: The most effective
method is to use wide, sweeping movements,
guiding the cutting edge of the blade straight
through the branches. A slight incline of the blade
downwards towards the movement will produce
best cutting results.
It is recommended to tie a guide line of string or
the like along the hedge so that you cut the
hedge to a level height. The branches above it
will be cut off. (Fig.6)
Cutting the side of a hedge: Cut the sides of
the hedge with curve-shaped movements from
the bottom up. (Fig. 7)
Please note: As a result of its design, if you work
with the machine on its side for a lengthy period
and the tank is not completely filled, the motor
may stall.
7. Cleaning, maintenance, storage
and ordering of spare parts
7.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
• We recommend that you clean the device
immediately each time you have finished using it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can
seep into the device.
12
Helpline No. UK 0151 649 1500 / IRE 189 094 6244
7.2 Maintenance
Always switch off the head trimmer and remove
the spark plug boot before carrying out any
maintenance work.
1. The cutter blades are high quality, made of
tempered steel and in normal use there is no
need to sharpen the blades. If you accidentally
strike a wire, stone, glass or other hard object, this
may cause a notch in the blade. There is no
need to remove the notch as long as it does not
adversely affect the movement of the cutting
edges. If it does adversely affect this movement,
switch off the machine and use a fine file or a
fine grinding stone to remove the notch. Ensure
that the blade's cutting edge is always well oiled
(see Fig. 8).
2. If you drop the hedge trimmer, check whether
it has suffered any damage. If it is damaged
Contact Helpline: 0151 649 1500
3. Only clean the machine after it has been
switched off. Use only mild soap and a damp
cloth to clean it. Never allow fluid to get into the
machine. Do not use caustic cleaning products.
7.2.1 Maintenance of the air filter (Fig. 9-11)
Soiled air filters reduce the engine output by
supply too little air to the carburettor.
Regular checks are therefore essential. The air filter
should be checked after every 25 hours of use
and cleaned if necessary. If the air contains a lot
of dust, the air filter should be checked more
frequently.
1. Remove the air filter cover (Fig. 9-10)
2. Remove the filter element (Fig. 11)
3. Clean the filter element by tapping it or
blowing it.
4. Assemble in reverse order.
Please note: Never clean the air filter with petrol
or inflammable solvents. Clean the air filter with
compressed air or by tapping it.
7.2.2 Maintenance of the spark plug (Fig.12-14C)
Spark plug gap = 0.025 inch (0.635 mm). Tighten
the spark plug with a torque of 12-15 Nm.
Check the spark plug for dirt and grime after 10
hours of operation and if necessary clean it with a
Advertisement
Table of Contents
