Trolling Motor Transducer Installation - Humminbird 917C Installation And Operation Manual

NOTE: Proper operation requires the end of the transducer that has the mounting
ears to face towards the bow of the boat.
7. Weight the transducer so that it will not move while the epoxy is
curing.
NOTE: When the epoxy cures, no water is necessary inside the hull.
8. If you unplugged the transducer cable at the beginning of this
procedure, plug it back into the control head.
NOTE: Neither water, spilled gasoline, nor oil will affect the performance of the
transducer.

Trolling Motor Transducer Installation

If you want to install the transducer on a trolling
motor, use this procedure. Several styles of the
transducer are compatible with trolling motor
mounting. If you have a trolling motor bracket,
refer to the separate installation instructions that
are included with the bracket.
NOTE: After trolling motor transducer installation, please perform the final
testing and then finalize the installation (see Test and Finish the Transducer
Installation).
24