3) Remove 2-pieces of screws for fixing the control board.
Fig. 2.3-3
4) Pull out the power board connector.
5) Finally, detach the flat cable for the printer connecting use.
Caution 1 : Be careful to pull out every connectors in their straight directions.
If any distortion of connector's front has been introduced in the pulling out operation,
it may cause unnecessary trouble (s) in the next operation work.
Caution 2 : Be careful to deal with the control board, because it contains a lot of IC.
CITIZEN
[1] Screws for fixing control board
[2] Screws for fixing control board
[3] Flat cable for printer connecting use
[4] Power board connector
6
iDP-562 Service Manual
BTP 3 x12
STP 3 x 14