Hot Swap - Buffalo TS-XL User Manual

Hot Swap

If a hard drive fails, you may replace it without
shutting down the TeraStation. The drive LED
for a failed drive will be red.
After replacing the hard drive, the LCD display
will show "SW I31 New DiskX Ready". Hold
down the function button for 3 seconds, until
it beeps. The TeraStation will rebuild the RAID
array automatically.
Only failed drives may be hot-swapped! If
your drive is operating normally, with green or
blinking LEDs, then you must dismount the
drive or shut down the TeraStation first before
changing it. To dismount a drive from within
the Web Admin tool, navigate to System/
Storage, select the drive, and click Remove
Disk.
0