Alarm silence Application and positioning Routine Maintenance Limitations Cleaning 13 & 14 How to install your FireAngel Repair 1. Remove shipping disablement ribbon Trouble shooting 2. Locate suitable lighting fixture a) Orientation What to do in case of fire in your home b) Type &...
INTRODUCTION This manual is for use with models PS-101 (white) and SPS-101 (silver) Plug-in Smoke Alarms. Note, that for information purposes, the PS-101 only has been used. Congratulations, you've made a wise investment in an innovative product and your personal safety. The FireAngel plug in smoke alarm is the first in a new generation of domestic life safety products from Sprue Aegis, which combines the latest technology and innovative design to provide an aesthetically pleasing and effective contribution to your fire safety.
FIREANGEL APPLICATION AND POSITIONING The minimum recommended application is one FireAngel to cover each floor and/or escape routes from individual sleeping areas. For comprehensive coverage we recommend one per room with the exception of bathrooms, shower-rooms and kitchens. The moist environments in bathrooms and shower-rooms are not suitable for Smoke Alarms and kitchens should be protected with self-contained Heat Alarms, as the combustion particles from cooking in kitchens will result in false alarms if Smoke Alarms are used.
WHAT ARE THE LIMITATIONS OF MY SMOKE ALARM? Your FireAngel is designed to alert you by sounding an alarm when it senses smoke, i.e. it can only sense smoke and alert you if smoke reaches it! If a fire develops in an area remote from the location of the FireAngel such as another room or another floor, smoke may not reach the FireAngel in sufficient time or quantity to sense and alert you to the danger.
Failure to remove the ribbon will render the FireAngel inoperative in the event of a fire emergency Note: Your fireangel may beep or start chirping once a minute on removal of shipping disablement ribbon. This is normal, read on for clarification.
The lampshade must be open at the top for two reasons. Firstly to allow smoke to enter the alarm from above and secondly to allow hot air to escape from the bulb and FireAngel. Please refer to the guide below for clarification.
Lightbulbs Your FireAngel is only intended for use with conventional bayonet light bulbs up to a maximum rating of 60 watts, and long life/low energy (PL Tube) type bulbs of any rating. Warning Using light bulbs above a 60 watt rating will significantly reduce the life span of your FireAngel and invalidate your warranty.
Ensure the selected light fitting is switched off and that the bulb is cool. Remove the bulb from the light fitting. a) Remove the lampshade b) Place the lampshade’s c) Fit your FireAngel into the d) Fit the bulb into the fixing skirt, to allow the fixing ring over your light fitting.
Page 10
Important Your FireAngel has been designed to fit within the arms of the majority of lampshades. If the arms on your lampshade are not wide enough apart to allow installation, simply ease apart until your FireAngel can be fitted. Important Your FireAngel has been designed to fit into modern light fixtures that use an average length fixing skirt.
Fully Charge Your FireAngel To ensure both the correct operation and maximum life span of your FireAngel it is necessary to fully charge the integral battery on installation. This process is best achieved by leaving the light switched on for at least 8 hrs.
Your FireAngel requires an electrical supply to recharge its integral battery. Only install in suitable light fittings that are used regularly. Your FireAngel requires the light to be switched on for a total of 1 hour per week to remain in its fully charged state.
Alarm Silence If your FireAngel alarms and you are not testing the unit, your FireAngel is warning you of a potentially dangerous situation that requires your immediate attention. Only use the alarm silence function after making sure that there is no ongoing fire emergency situation.
Important If your FireAngel continues to 'chirp' after completion of the re-set cycle, it is notifying you of a low battery condition. In this case leave the light switched on for approximately 8 hours to fully re-charge the integral battery.
Page 15
Important If you are unable to access your FireAngel whilst in its fitted position, remove from lighting fixture and hold in hand whilst cleaning. Ensure the light is switched off and the bulb is cold. Holding the outside of the...
If your FireAngel is not operating properly, see 'TroubleShooting'. • If you cannot solve the problem, and your FireAngel is still under warranty, return your FireAngel to Sprue Aegis (see Warranty). • If your FireAngel is no longer under warranty, replace immediately with a comparable FireAngel brand Smoke Alarm.
WHAT TO DO IN CASE OF FIRE IN YOUR HOME If you have made a family escape plan and practised it with your family, you have increased their chances of escaping safely. Go over the following rules with your children each time you have fire drills. This will help everyone remember them in case of a real emergency.
HOW TO MAKE YOUR HOME SAFER Installing smoke alarms is only one step in protecting your family from fires. You must also reduce the chances that fires will start in your home. And you must increase your chances of escaping if one does start. To have a good fire safety program you must: 1.
Page 19
4. Develop a family escape plan and practice it with your entire family. Be sure to include small children In your practice. • Draw a floor plan of your home, and find two ways to exit from each room. There should be one way to get out of each room without opening the door.
To return your FireAngel under warranty, send it suitably packed and disabled (this will be explained by the FireAngel technical support engineer) with postage prepaid; a note indicating the return number and describing the nature of the difficulty, with proof of date of purchase to: Sprue Aegis plc.
NOTES For instructions on how to refit the Tape ribbon here. shipping disablement ribbon for transportation or storage, please see our website: www.fireangel.co.uk or call the technical support line (see page 15).
Page 22
Conforms to BS 5446-1:2000 / BS EN 61184 / BS EN 60065 Technical Support Line 024 7623 6663 (1-800 523171 in Eire) E-mail: technicalsupport@fireangel.co.uk Web: www.fireangel.co.uk FireAngel Ltd. The Technocentre, Puma Way, Coventry CV1 2TT England Ref: SA0137 R5...
Need help?
Do you have a question about the PS-101 and is the answer not in the manual?
Questions and answers