EnGenius M5000 User Manual page 70

Mesh
Step1
Step2
Step3
Step4
Step5
Step6
Step7
Step8
Step9
Note: Non-M35 product may find difficulty of configuration.
Access Point
Step1
Step3
Step4
Note: For more advanced settings, please refer to the previous chapters.
Wireless Client
Step1
Step2
Step3
Step4
Auction: Wireless Client IP address must configure manually at the same subnet in Local Area
Login to the web-based configuration interface with default IP 192.168.1.1
Select your country or region's regulation.
Change device mode to Mesh from System Properties.
Select wireless mode you would like to associate with.
Select channel/frequency you would like to associate with.
Specify SSID for the Mesh Network.
Setup the authentication settings.
Specify current device is a gateway or relay.
Press Apply to save all changes.
Specify the SSID for your broadcast SSID and you can also configure multiple SSID at
the same time.
Setup the authentication settings.
Press Apply to save all changes.
Select wireless mode you would like to associate with.
Use site survey to scan nearby Access Point and select the certain AP you would like
to connect with or enter SSID manually.
Configure VLAN ID in your wireless device if available.
Select correct authentication type and password.
69