Fuel Gauge; Direction Selector; Accelerator Pedal; Brake And Park Brake - Cushman HAULER 1200X Owner's Manual

INTRODUCTION
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

3. Fuel Gauge

The fuel gauge (if equipped) will either be located on the dash panel (electric) or directly on the fuel tank
(mechanical).

4. Direction Selector

3
To reduce the possibility of component damage, the vehicle must be completely stopped before moving the direc-
tion selector.
Located on the seat support panel, this lever permits the selection of either 'F' (forward) or 'R' (reverse). Vehicle
should be left in 'F' when unattended.

5. Accelerator Pedal

Unintentional movement of the accelerator pedal will release the park brake and may cause the
vehicle to move which could result in severe injury or death.
With the key switch 'ON', depressing the accelerator pedal starts the engine. When the pedal is released, the engine
will stop. To stop the vehicle more quickly, depress the service brake.
If key switch is 'ON' and park brake is set, depressing the accelerator inadvertently will release the park brake and
will cause the vehicle to move which could cause severe injury or death.
Depressing the accelerator pedal will release the park brake if it is engaged. This is a feature to assure the vehicle is
not driven with the park brake engaged. Depressing the accelerator pedal is not the preferred method of releasing
the park brake.
Depressing the lower section of the brake pedal is the preferred method of releasing the park brake to assure the
longest service life of brake components.

6. Brake and Park Brake

The brake pedal incorporates a park brake feature. To engage, push down on the upper section of the pedal until it
locks in place. The park brake will release when the service brake pedal is depressed. Use the lower section of the
brake pedal to operate the service brake system.

7. Horn

The horn is operated by pushing the horn button located on the floor to the left of the brake pedal.

8. Front Seats

The split bench front seat is designed for one occupant on each side of the center console.

9. Hip Restraint - Front

The front hip restraints are designed to help keep the occupants properly positioned in the event of sudden vehicle
position changes.

10. Front Lights

3 - 4