Venting Information - HearthStone 8160 Owner's Manual

HearthStone Quality Home Heating Products, Inc.
V I
ENTING NFORMATION
V C
ENT ONNECTION
1. The Luno Direct
installation only with the vent connecting
components listed; Simpson Dura-Vent Direct
Vent GS, AmeriVent Direct, Selkirk Direct
Temp™ or Secure Vent systems. Use the
following instructions along with the pipe
manufacturer's instructions to complete the
installation.
2. Install the vent system according to the
manufacturer's instructions.
R P
ESTRICTION LATE
There is a vent restriction plate that adjusts the
flow rate of exhaust gases. This ensures proper
flame characteristics and efficiency for the wide
variety of vent configurations. Controlling the draft
also changes the aesthetics of the flame.
restriction plate consists of a rotating shutter in the
flue connector. This shutter is attached to a rod
that protrudes through the back of the pipe. This
rod has a lock nut attached. On the very end of the
rod is an indicator slot. This slot shows the relative
position of the restrictor shutter. If the slot is
pointing up and down (12+ 6 o'clock position) the
restrictor is open. If it is pointing left and right (9+3
o'clock, the restrictor is in the closed position.
The restriction plate
Depending on the vent configuration, you may be
required to adjust the restriction plate position.
Vent is approved for
The
has unlimited settings.
Once the desired position is reached, use a 7/16"
wrench to lock down the hex nut.
Figure 2: Restrictor in open position
Figure 3: Restrictor in closed position
10
Luno Model #8160
OPEN
CLOSED