Set The Display Language; Using Your Phone - AEG SOLO 10 User Manual

5.5 Text and Number Entry
The following table shows you where each letter and punctuation character can be found, by using
repeated presses of the alphanumeric keypad. This will be helpful when storing a name in the phonebook
or renaming your handset.
For example, to enter the name Tom:
T Press 8 once
O Press 6 three times
M Press 6 once
In editing mode, a cursor is displayed to indicate the current text entry position.
It is positioned at the right of the last character entered.
Writing Tips:
Once a character is selected, the cursor will move to the next position after a short pause.
Press to delete the last letter or number.
6

SET THE DISPLAY LAnGUAGE

You can select different display languages.
• From the home screen, press
• Press to "PERSONAL SET" and then press
• Press to "LANGUAGE" and then press
• Press to select your preferred language and then press
>A confirmation beep is played.
• Press to return to standby mode.
Note:
Once the display language is set, the handset will switch to display in the selected language immediately.
7

USInG YOUR PHOnE

7.1 Make a Call
7.1.1 Pre-dialling
• Enter the phone number (maximum 24 digits).
• If you make a mistake, press
• Press to dial the phone number.
7.1.2 Direct Dialling
• Press .
• Dial the number (maximum 24 digits).
Note:
If you make a mistake, you cannot correct it with the
Press and then press
7.1.3 Call from the Redial List
• Press key in standby mode.
>The last number dialled is displayed.
• Press to select the desired entry in the redial list and then press
number.
.
to delete the last entered number.
to return to the home screen.
to select.
to select.
to confirm.
key.
to dial out the selected redial
6