AEG SOLO 10 User Manual page 8

7
7.1.4 Call from the Call Log
• Press in standby mode.
• Press to select the desired entry in the call log and then press
number.
Note:
You need to subscribe to Caller Line Identification service to be able to see the caller's number or name
in the call log.
7.1.5 Call from the Phonebook
• Press key in standby mode.
• Press to select the desired entry in the phonebook and then press
phonebook number.
7.2 Answer and End a Call
• When the phone rings, press
• To end a conversation, press .
Warning:
When the handset is ringing, please do not hold it too close to your ear as the volume of the ringing tone
may damage your hearing.
Note:
You can simply place the handset back on its base station or charger pod to end the call. Make sure that
you have not deactivated the Auto hang-up feature.
7.3 Handset Speakerphone
During a call, you can press
7.4 Adjust Earpiece Volume
There are 3 levels of earpiece volume.
• During a call, press
>The current setting is shown.
>When you end the call, the setting will remain at the last selected level.
7.5 Adjust Speaker Volume
There are 5 levels of speaker volume.
• During a call, press
>The current setting is shown.
>When you end the call, the setting will remain at the last selected level.
7.6 Mute/Unmute the Microphone
When the microphone is muted, the handset displays "MUTE ON", and your caller cannot hear you.
During a call, press
7.7 Paging
The paging feature enables you to locate a missing handset if the handset is in range and contains
charged batteries.
• Press under the base unit.
>All the registered handsets that are in range will start to ring.
You can stop the paging by pressing any key on the handset or the
7.8 Switching the Handset On/Off
• Press and hold for more than 2 seconds to switch the handset on or off in standby mode.
>The display will show "SEARCHING..." until the handset finds the base.
.
to alternate between hands-free speakerphone and handset earpiece.
to select from "VOLUME 1" to "VOLUME 3".
to select from "VOLUME 1" to "VOLUME 5".
to turn on/off the microphone.
to dial out the selected call log
to dial out the selected
under the base unit again.