Hyundai Tiburon Owner's Manual page 88

B970C02E-AAT
Automatic Operation
The FATC (Full Automatic Temperature Con-
trol) system automatically controls heating and
cooling as follows:
1. Push the "AUTO" switch. The indicator light
will illuminate confirming that the Face, Floor
and/or Bi-Level modes as well as the blower
speed and, air conditioner will be controlled
automatically.
gkflhma-1b.p65 77
2. Push the "TEMP" button to set the desired
HGK2106
temperature.
The temperature will increase to the maxi-
mum 90°F(32°C) by pushing on the
Each push of the button will cause the tem-
perature to increase by 1°F(0.5°C).
The temperature will decrease to the mini-
mum 62°F(17°C) by pushing on the
Each push of the button will cause the tem-
perature to decrease by 1°F(0.5°C).
FEATURES OF YOUR HYUNDAI
NOTE:
If the battery has been discharged or dis-
connected, the temperature mode will reset
to centigrade degrees.
This is a normal condition and you can
change the temperature mode from centi-
grade to farenheit as follows;
Press the TEMP button down 3 seconds or
OUTSIDE
more with the button held down. The
TEMP
display shows that the unit of temperature
is adjusted to centigrade or fahrenheit.
(°C → → → → → °F or °F → → → → → °C)
HGK2103
button.
Photo sensor
button.
NOTE:
Never place anything over the sensor which
is located on the instrument panel to en-
sure better control of the heating and cool-
ing system.
9/8/04, 5:37 PM
1
77
HGK2076