Changing The Oil And Filter - Hyundai Tiburon Owner's Manual

6
DO-IT-YOURSELF MAINTENANCE
6
G030D01A-AAT
Adding Oil
2.0L 2.7L
If the oil level is close to or below the "L" mark,
add oil until it reaches the "F" mark. To add oil:
1. Remove the oil filler cap by turning it counter-
clockwise.
2. Add oil, then check the level again. Do not
overfill.
3. Replace the cap by turning it clockwise.
The distance between the "F" and "L" marks is
equal to about 1 quart of oil.
gkflhma-6.p65 6

CHANGING THE OIL AND FILTER

G040A03GK-AAT
2.0L
Oil filler cap
Oil filter
HGK5005
2.7L
Oil filler cap
Oil filter
The engine oil and filter should be changed at
those intervals specified in the maintenance
schedule in Section 5. If the car is being driven
in severe conditions, more frequent oil and filter
changes are required.
The procedure for changing the oil and filter is
as follows:
1. Park the car on level ground and set the
parking brake. Start the engine and let it
warm up until the needle on the coolant
temperature gauge moves above the lowest
Drain plug
mark. Turn the engine off and place the gear
selector lever in "P" (automatic) or reverse
G040A03E
gear (manual transaxle).
2. Open the hood and remove the engine oil
filler cap.
3. Slide underneath the car and loosen the
drain plug by turning it counterclockwise with
a wrench of the proper size. Be sure that a
drain pan is in position to catch the oil as it
drains out, then remove the drain plug.
!
WARNING:
Be very careful when draining the engine oil
G040A01B
as it may be hot enough to burn you!
9/8/04, 5:30 PM