Honeywell STT850 SMARTLINE User Manual page 45

Select Input
Sensor n Type
Sensor n ID
RTD n Type
RTD n Lead Wire
Sensor n Bias
Sens n Cal Lo Pt
Sens n Cal Hi Pt
Reset Cal n Corr
Screen Rotate
Select Screen
Screen
Screen PV
Screen Decimal
Revision 1
1 - 8
mV, TC, RTD, Ohm
Sensor Identifier
2-Wire, 3-Wire, 4-Wire
Resistance of Input n
RTD lead wires
####.##
####.##
####.##
Enabled
Disabled
1 through 8
Enabled/Disabled
Loop PV
Sensor 1
Sensor 2
CJ Temperature
Sensor 1 Resistance
Sensor 2 Resistance
Loop Output
Percent Output
None
X.X
X.XX
X.XXX
STT850 Temperature Transmitter User's Manual
Select Input number to configure,
referred to as "n" in subsequent
menu items
Select Sensor Type
Select Sensor ID for Input n for
selected Sensor Type
Select the RTD Type according to
the number of lead wires
Select the lead wire resistance for
2-Wire RTD Types
Bias value which is applied to the
Input n measured value
Calibration low point for Sensor n
Calibration high point for Sensor n
Executing this selection resets the
Sensor 1 calibrations back to
Factory values
Select to enable or disable the
automatic rotation of Screens
Select Screen to configure.
Select to enable or disable the
screen for display and
configuration
Select the Process Variable (PV)
that will be shown on the screen.
Sensor Resistance is only
available for RTDs and will read 0
for thermocouples
Select the decimal resolution for
the PV
Press ↵ to enter
menu selection
↑ and ↓ to select
↵ to enter
entry.
Page 35