Battery charger for nickel metal hydride type rechargeable batteries (5 pages)
Summary of Contents for Xenotronix HPX150 Series
Page 1
B R A N D Model HPX150 Series Automatic Battery Charger User’s Manual Rev. 1.0 October 17, 2006 For Sales, Support and Service phone: 407-331-4793 fax: 407-331-4708 website: www.xenotronix.com email: information@xenotronix.com Xenotronix/TLI, Inc. 2541 Tracy Road Toledo, Ohio 43619 Phone: 419-666-6982...
Page 2
Notice to the User The information contained in this manual is believed to be correct. However, Xenotronix/TLI, Inc. assumes no responsibility for any inaccuracies therein. Information in this manual is subject to change without notice. No part of this manual may be reproduced or transmitted in any form, electronic or mechanical, for any purpose, without the express written permission of Xenotronix/TLI, Inc.
Refer service to qualified service personnel. Recharge batteries in well ventilated areas to prevent build-up of explosive gases. Allow space around the unit and adequate air circulation to reduce internal heat buildup. Do not block vents or operate in a small, enclosed space. Xenotronix/TLI...
Connect the red insulated output clip to the positive battery terminal and connect the black insulated output clip to the negative battery terminal. If the charger is provided with a polarized connector, make sure your battery connector is wired to match the output connector. Xenotronix/TLI...
Should this occur the battery may become damaged due to over charging. In such a case, the capacity is too great and the battery should be charged with a higher current charger or a parallel charger. Xenotronix/TLI...
Xenotronix/TLI can make custom units, or modify our existing units, to exactly match your charging needs. Call our sales department for technical information and pricing.
HPX150 User’s Manual Model HPX150 Series Automatic Parallel Battery Charger Supplemental Instructions IMPORTANT PRECAUTIONS Follow the battery manufacturer’s recommendations when selecting a battery for use with this unit. The battery should be able to accept the full rated output current of this unit or the battery may be damaged if the load is disconnected with the battery in a discharged condition.
Output Ratings (standard calibration): Model HPX150-012P1000 HPX150-24P0500 Charge Amps 10 A Maximum Continuous Load 5 A 2.5 A Voltage 13.60 VDC 27.20 VDC Other Models (standard calibration): Charge Amps see marking label Maximum Continuous Load ½ of Charge Amps Voltage 2.267 V/Cell Xenotronix/TLI...