Advertisement
Quick Links
B R A N D
Model NDX40 Series
Automatic Battery Charger
User's Manual
Rev. 1.0
October 17, 2006
For Sales, Support and Service
phone: 407-331-4793
fax: 407-331-4708
website: www.xenotronix.com
email: information@xenotronix.com
Xenotronix/TLI, Inc.
2541 Tracy Road
Toledo, Ohio 43619
Phone: 419-666-6982
Fax: 419-666-6534
Advertisement
Related Manuals for Xenotronix NDX40 Series
Summary of Contents for Xenotronix NDX40 Series
- Page 1 B R A N D Model NDX40 Series Automatic Battery Charger User’s Manual Rev. 1.0 October 17, 2006 For Sales, Support and Service phone: 407-331-4793 fax: 407-331-4708 website: www.xenotronix.com email: information@xenotronix.com Xenotronix/TLI, Inc. 2541 Tracy Road Toledo, Ohio 43619 Phone: 419-666-6982...
- Page 2 Notice to the User The information contained in this manual is believed to be correct. However, Xenotronix/TLI, Inc. assumes no responsibility for any inaccuracies therein. Information in this manual is subject to change without notice. No part of this manual may be reproduced or transmitted in any form, electronic or mechanical, for any purpose, without the express written permission of Xenotronix/TLI, Inc.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Model NDX40 Automatic Battery Charger – User’s Manual Important Safety Instructions ........1 Introduction . -
Page 4: Important Safety Instructions
Refer service to qualified service personnel. Recharge batteries in well ventilated areas to prevent build-up of explosive gases. Allow space around unit and adequate air circulation to reduce internal heat buildup. Do not operate in a small, enclosed space. Xenotronix/TLI... -
Page 5: Introduction
OPERATING INSTRUCTIONS Before using this battery charger, make sure that it is compatible with your battery. Refer to the battery charger, the specifications in this manual, and your battery documentation. Xenotronix/TLI... - Page 6 READY mode. When attempting to charge a dead battery pack (less than about 1 volt) the charger will initially start out in the READY mode. When the battery voltage rises, the charger will switch into the CHARGE mode. If the Xenotronix/TLI...
-
Page 7: Custom Units Note
CUSTOM UNITS NOTE Xenotronix/TLI can make custom units, or modify our existing units, to exactly match your charging needs. Call our sales department for technical information and pricing. Following are some of the modifications we can perform:... -
Page 8: Battery Charger Specifications
15 to 35 ºC (59 to 90 ºF) Ambient Storage Temperature -40 to 80 ºC (-40 to 176 ºF) Dimensions W 5.5” (14 cm) x D 3.5” (8.9 cm) x H 2.9” (7.3 cm) Weight About 4 lbs (1.8 kg) with standard output cable Xenotronix/TLI... -
Page 9: Dimensions
NDX40 User’s Manual DIMENSIONS TOP VIEW CHARGING READY FRONT VIEW BACK VIEW Xenotronix/TLI...