Table of Contents
Advertisement
Quick Links
B R A N D
Model HPX10 Series
Automatic Battery Charger
User's Manual
Rev. 1.0
October 17, 2006
For Sales, Support and Service
phone: 407-331-4793
fax: 407-331-4708
website: www.xenotronix.com
email: information@xenotronix.com
Xenotronix/TLI, Inc.
2541 Tracy Road
Toledo, Ohio 43619
Phone: 419-666-6982
Fax: 419-666-6534
Advertisement
Table of Contents
Related Manuals for Xenotronix HPX10 Series
Summary of Contents for Xenotronix HPX10 Series
- Page 1 B R A N D Model HPX10 Series Automatic Battery Charger User’s Manual Rev. 1.0 October 17, 2006 For Sales, Support and Service phone: 407-331-4793 fax: 407-331-4708 website: www.xenotronix.com email: information@xenotronix.com Xenotronix/TLI, Inc. 2541 Tracy Road Toledo, Ohio 43619 Phone: 419-666-6982...
- Page 2 Notice to the User The information contained in this manual is believed to be correct. However, Xenotronix/TLI, Inc. assumes no responsibility for any inaccuracies therein. Information in this manual is subject to change without notice. No part of this manual may be reproduced or transmitted in any form, electronic or mechanical, for any purpose, without the express written permission of Xenotronix/TLI, Inc.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Model HPX10 Automatic Battery Charger – User’s Manual Important Safety Instructions ........1 Introduction . -
Page 4: Important Safety Instructions
Do not disassemble charger; incorrect reassembly will result in the risk of an electric shock or fire. Refer service to qualified service personnel. Allow space around unit and adequate air circulation to reduce internal heat buildup. Do not block vents or operate in a small, enclosed space. Xenotronix/TLI... -
Page 5: Introduction
Charge only sealed or valve regulated, lead-acid, non-automotive, maintenance free rechargeable batteries. Attempting to charge other types of batteries may result in battery damage. Xenotronix/TLI... -
Page 6: Charging Notes And Tips
These battery chargers are designed to charge a battery at the C/10 rate (battery capacity divided by 10 hours). Therefore, an 8 amphours battery would require an 800 milliamp charge. Larger or smaller capacity batteries can be charged with these chargers with the Xenotronix/TLI... -
Page 7: Troubleshooting
Xenotronix/TLI can make custom units, or modify our existing units, to exactly match your charging needs. Call our sales department for technical information and pricing. -
Page 8: Maintenance Instructions
107 mA Float Voltage 6.80 VDC 13.60 VDC Other Models (standard calibration): Charge Amps see marking label Charge Voltage 2.40 V/Cell Switch Amps approx. Charge Amps/7.5 Float Voltage 2.267 V/Cell Safety Agency Approval CSA NRTL/C (USA and Canada) Xenotronix/TLI... -
Page 9: Battery Recommendations
HPX10 User’s Manual BATTERY RECOMMENDATIONS Lead-acid batteries charged @ C/10 rate. Smaller capacity batteries may require a smaller charge current to be safely charged. Consult the battery manufacturer or Xenotronix/TLI. Model Battery HPX10-06C100 6 V, 10 Ah HPX10-12C080 12 V, 8 Ah... -
Page 10: Important Precautions
HPX10 User’s Manual Model HPX10 Series Automatic Parallel Battery Charger Supplemental Instructions IMPORTANT PRECAUTIONS Follow the battery manufacturer’s recommendations when selecting a battery for use with this unit. The battery should be able to accept the full rated output current of this unit or the battery may be damaged if the load is disconnected with the battery in a discharged condition. -
Page 11: Battery Charger Specifications
HPX10-06P100 HPX10-12P080 Charge Amps 1000 mA 800 mA Maximum Continuous Load 500 mA 400 mA Voltage 6.80 VDC 13.60 VDC Other Models (standard calibration): Charge Amps see marking label Maximum Continuous Load ½ of Charge Amps Voltage 2.267 V/Cell Xenotronix/TLI...