Table of Contents
Advertisement
Quick Links
B R A N D
Model HPX30 Series
Automatic Battery Charger
User's Manual
Rev. 1.0
October 17, 2006
For Sales, Support and Service
phone: 407-331-4793
fax: 407-331-4708
website: www.xenotronix.com
email: information@xenotronix.com
Xenotronix/TLI, Inc.
2541 Tracy Road
Toledo, Ohio 43619
Phone: 419-666-6982
Fax: 419-666-6534
Advertisement
Table of Contents
Related Manuals for Xenotronix HPX30 Series
Summary of Contents for Xenotronix HPX30 Series
- Page 1 B R A N D Model HPX30 Series Automatic Battery Charger User’s Manual Rev. 1.0 October 17, 2006 For Sales, Support and Service phone: 407-331-4793 fax: 407-331-4708 website: www.xenotronix.com email: information@xenotronix.com Xenotronix/TLI, Inc. 2541 Tracy Road Toledo, Ohio 43619 Phone: 419-666-6982...
- Page 2 Notice to the User The information contained in this manual is believed to be correct. However, Xenotronix/TLI, Inc. assumes no responsibility for any inaccuracies therein. Information in this manual is subject to change without notice. No part of this manual may be reproduced or transmitted in any form, electronic or mechanical, for any purpose, without the express written permission of Xenotronix/TLI, Inc.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Model HPX30 Automatic Battery Charger – User’s Manual Important Safety Instructions ........1 Introduction . -
Page 4: Important Safety Instructions
Refer service to qualified service personnel. Recharge batteries in well ventilated areas to prevent build-up of explosive gases. Allow space around unit and adequate air circulation to reduce internal heat buildup. Do not operate in a small, enclosed space. Xenotronix/TLI... -
Page 5: Introduction
Connect the red insulated output clip to the positive battery terminal and connect the black insulated output clip to the negative battery terminal. If the charger is provided with a polarized connector, make sure your battery connector is wired to match the output connector. Xenotronix/TLI... -
Page 6: Charging Notes And Tips
When charging a smaller capacity battery, the battery may be undercharged because the charger switches into float charge mode too early (relative to Xenotronix/TLI... -
Page 7: Troubleshooting
Xenotronix/TLI can make custom units, or modify our existing units, to exactly match your charging needs. Call our sales department for technical information and pricing. -
Page 8: Maintenance Instructions
Switch Amps approx. 267 mA approx. 133 mA Float Voltage 13.60 VDC 27.20 VDC Other Models (standard calibration): Charge Amps see marking label Charge Voltage 2.40 V/Cell Switch Amps approx. Charge Amps/7.5 Float Voltage 2.267 V/Cell Safety Agency Approval: Xenotronix/TLI... -
Page 9: Battery Recommendations
HPX30 User’s Manual BATTERY RECOMMENDATIONS Lead-acid batteries charged @ C/10 rate. Smaller capacity batteries may require a smaller charge current to be safely charged. Consult the battery manufacturer or Xenotronix/TLI. Model Battery HPX30-12C200 12 V, 20 AH HPX30-24C100 24 V, 10 AH AH = Ampere-hours. -
Page 10: Important Precautions
HPX30 User’s Manual Model HPX30 Series Automatic Parallel Battery Charger Supplemental Instructions IMPORTANT PRECAUTIONS Follow the battery manufacturer’s recommendations when selecting a battery for use with this unit. The battery should be able to accept the full rated output current of this unit or the battery may be damaged if the load is disconnected with the battery in a discharged condition. -
Page 11: Battery Charger Specifications
Output Ratings (standard calibration): Model HPX30-012P200 HPX30-24P100 Charge Amps Maximum Continuous Load 1 A 500 mA Voltage 13.60 VDC 27.20 VDC Other Models (standard calibration): Charge Amps see marking label Maximum Continuous Load ½ of Charge Amps Voltage 2.267 V/Cell Xenotronix/TLI...