Table of Contents
Advertisement
Quick Links
B R A N D
Model MHTX7 Series
Automatic Battery Charger
User's Manual
Rev. 1.0
October 17, 2006
For Sales, Support and Service
phone: 407-331-4793
fax: 407-331-4708
website: www.xenotronix.com
email: information@xenotronix.com
Xenotronix/TLI, Inc.
2541 Tracy Road
Toledo, Ohio 43619
Phone: 419-666-6982
Fax: 419-666-6534
Advertisement
Table of Contents
Related Manuals for Xenotronix MHTX7 Series
Summary of Contents for Xenotronix MHTX7 Series
- Page 1 B R A N D Model MHTX7 Series Automatic Battery Charger User’s Manual Rev. 1.0 October 17, 2006 For Sales, Support and Service phone: 407-331-4793 fax: 407-331-4708 website: www.xenotronix.com email: information@xenotronix.com Xenotronix/TLI, Inc. 2541 Tracy Road Toledo, Ohio 43619 Phone: 419-666-6982...
- Page 2 Notice to the User The information contained in this manual is believed to be correct. However, Xenotronix/TLI, Inc. assumes no responsibility for any inaccuracies therein. Information in this manual is subject to change without notice. No part of this manual may be reproduced or transmitted in any form, electronic or mechanical, for any purpose, without the express written permission of Xenotronix/TLI, Inc.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Model MHTX7 Automatic Battery Charger – User’s Manual Important Safety Instructions ........1 Introduction . -
Page 4: Important Safety Instructions
Do not disassemble charger; incorrect reassembly will result in the risk of an electric shock or fire. Refer service to qualified service personnel. Allow space around unit and adequate air circulation to reduce internal heat buildup. Do not block vents or operate in a small, enclosed space. Xenotronix/TLI... -
Page 5: Introduction
While in a reversed condition the charger will indicate that it is in the charging mode. However, it may actually be discharging the battery until either the battery or charger is damaged. Xenotronix/TLI... -
Page 6: Charging Notes And Tips
115 volts ac input. If the input voltage is below 115 volts at that charge voltage, the maximum current will begin to drop and the battery may not be fully charged. Attempting to charge 4 Ah batteries between 1.2 to 3.6 volts (1 to 3 cells) may Xenotronix/TLI... -
Page 7: Troubleshooting
4500 5000 BATTERY CAPACITY (mAh) Xenotronix/TLI can make custom units, or modify our existing units, to exactly match your charging needs. Call our sales department for technical information and pricing. Following are some of the modifications we can perform: o Custom match the charge current to your battery capacity... -
Page 8: Maintenance Instructions
(Approximately 1/4 of rated output current) Charge Timer 14 hours ± 1 hr. Open Circuit Voltage Greater than 20 VDC Battery Rechargeable nickel-metal-hydride, 1.2 to 14.4 Volts (1 to 12 cells), 500 mAh to 5 Ah Safety Agency Approval CSA NRTL/C (USA and Canada) Xenotronix/TLI... -
Page 9: Dimensions
MHTX7 User’s Manual DIMENSIONS READY CHARGING CAUTION: Xenotronix/TLI...